In short
- Calibrate each crop at several flow rates against a certified scale, and write both numbers down.
- Check moisture, ground speed and true header width, because all three change yield per acre.
- Keep a log by season and ask custom operators and data services for their records and data terms.
Why calibration matters
A yield monitor does not weigh grain the way a scale does. It estimates flow from a sensor, adds moisture, speed and cutting width, and reports a number per acre. Small errors in any piece add up, and the map you pay an agronomist to read can mislead you. Follow your combine manual and monitor manufacturer instructions for the exact procedure, since each brand differs. The log below gives you a place to keep the numbers. Calibrate at the start of harvest, whenever you change crops or hybrids with very different moisture, and after any repair near the grain path. Record the date, crop, field, moisture and operator at the top of each entry.
Load-cell and flow calibration
Most monitors ask for several calibration loads at different flow rates, typically light, medium and heavy, as your manual specifies. Harvest a known length of a representative strip, then weigh that grain on a certified scale, such as a grain cart scale or the elevator scale. Enter the scale weight into the monitor. Here is a simple check. Suppose the monitor says a load was 9,600 pounds and the certified scale reads 10,000. The monitor is low by 400 pounds, which is 4 percent (400 divided by 10,000). The calibration factor should rise by about 4 percent, but let the monitor do the arithmetic through its procedure. Write down both weights and the percent difference. Keep tickets as proof.
Moisture sensor and test weight
Moisture matters because yield is reported at a standard moisture. Compare the monitor reading with a trusted hand meter and the elevator reading for the same load. Handheld meters vary, so use the same one every season and compare against the elevator. If the monitor reads two points wet and your handheld says otherwise, adjust per the manual and note it. Record the offset by crop. Clean the sensor plate, since dirt and crop residue skew readings. Check test weight settings if your monitor uses them. Do not adjust moisture to make a number look better; the goal is an accurate map, not a pretty one.
Speed, header width and swath
Yield per acre depends on acres. Check ground speed against a measured distance: mark off 500 feet, drive it, and time it. At 4 miles per hour, you travel 5.87 feet per second (4 times 5,280 divided by 3,600), so 500 feet takes about 85 seconds. If your time is far off, recalibrate speed. Then check header width. A 40 foot header that cuts only 37 feet in a typical pass inflates yield. Enter the width you really cut, or use the monitor's swath-width tool, and note overlap. Also set the header height and the delay for grain travel as the manual says. Wrong delay smears the map across the field.
Reading the log and spotting drift
Once you have entries, look for patterns. If every load needs a 3 percent bump up, the sensor may be dirty or worn. If error changes with crop or moisture, check the sensor and the settings. Compare the monitor totals with the elevator total for the field. A gap of a couple of percent may be normal, and a wider gap deserves a call to the dealer. Mistakes to avoid: calibrating on a half-full header, using the wrong scale, forgetting to clear old calibration after switching crops, and trusting one load alone. If you hire a custom harvester, ask whether their monitor is calibrated, and ask to see their log.
Putting it in writing
Keep a page per combine and per season. Columns to use: date, crop, field, flow rate, monitor weight, scale weight, percent difference, moisture offset, speed check, who calibrated. Keep elevator tickets with it. If a landlord, crop insurer or lender asks for production records, rules and requirements vary, so confirm with your insurance agent and the relevant agency. For data sharing, ask any agronomy or precision service in writing who owns your yield data and how it can be used. Look up your state in the directory to find precision ag providers.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
