In short
- Record sheep per comb and cutter set so you know when to sharpen or replace.
- Oil, clean and inspect handpieces and cords daily, and follow the maker's manual.
- Service and store equipment after shearing, and list what to buy before next season.
Why Keep a Log at All
Shearing is hard on equipment and harder on sheep when the gear is dull. A dull comb and cutter drags wool, heats up and can nick skin, and the shearer works twice as hard for a worse job. A log turns guessing into a pattern. After a season or two, you can see how many sheep a set of cutters handles before it needs a touch-up, which fleeces were dirty enough to dull edges fast, and when a handpiece started to run hot. It also helps when you hire a crew, since you can show them the equipment condition and ask them to follow it. Keep the log on a clipboard in the shearing area, with a pencil, because pens and lanolin do not get along.
What to Record Each Day
Make one line per day or per shearer. Write the date, the shearer, the equipment set used, number of sheep or ewes and rams separately, and the fleece condition: dry, wet, heavy with vegetable matter, sandy or burred. Note each change of comb and cutter and how many sheep were shorn on each set. Record any problems such as pulling, skipped cuts, hot handpieces, strange noises or cord damage. Note who sharpened the cutters and where. Weigh in simply: sheep per set is the number that matters most. If one shearer gets sixteen head from a set and another gets ten on the same type of sheep, that tells you something about technique, sharpening or the sheep.
Daily Care Steps
Follow the manufacturer's manual for oil type and spacing, since different handpieces have different needs. As a general habit, oil the comb and cutter before starting, oil again at intervals during the run, and wipe wool and grease off between sheep. Check tension according to the manual, because too tight heats the blades and too loose lets wool slip through. Clean the handpiece and look at the cord, plug and switch for damage. Keep the electrical connections dry and use a ground fault protected outlet. Blow out or brush dust from the motor vents. Record any part replaced, such as a bearing, downtube, belt or cord.
Sharpening and Replacement
Combs and cutters wear with each sheep, and sharpening on a flat grinding plate or an automated grinder restores the edge. Record each sharpening: date, who did it, which set and how many sheep were shorn since the last one. Set the interval from your own numbers and the maker's advice, not a rule from the internet, because wool type, dirt and grit change everything. Replace combs with broken or missing teeth and cutters that are chipped, since a damaged tooth can cut the animal. Keep spare sets so a shearer is never forced to work with a dull one to finish the pen. Mark sets with paint or tape so you can track them.
Seasonal Storage and Servicing
After shearing ends, clean everything. Remove grease with solvent suitable for the equipment, dry the parts, oil them and store them in a dry, closed box. Drain and flush any grease from gearboxes if the manual calls for it. Have the motor and handpiece serviced by a dealer or a repair shop that works on shearing equipment, and record the date and what was done. Check the overhead drive or flexible shaft for wear. Replace worn electrical cords. Write in the log what you need to buy before next season, such as combs, cutters, oil, spare belts and cords, so you are not shopping the week before the crew arrives.
Working With a Hired Shearer
If a contract shearer brings his own equipment, ask how often he sharpens and replaces gear, and whether he maintains a record. Agree on the number of sheep, pen layout, power supply and clean, dry sheep, because wet wool is a hazard to the animal and the shearer. Put the price, travel fees, any minimums and cancellation terms in writing. Ask about insurance and who is responsible for injuries. Rules for hired labor and workers' compensation differ by state; confirm with your state labor agency or insurance agent. Look up your state in the directory for shearing and wool services.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
