In short
- Change oil and filters before storage and drain every water line, pump and sprayer.
- Charge batteries, then disconnect them or use a maintainer as the manual directs.
- Block intakes and exhausts against mice, and tag the covers so you remove them in spring.
Wash and inspect first
Start by cleaning each machine. Dirt and residue hold moisture against metal, attract rodents and hide leaks and cracks. Wash, let dry, then walk around with a flashlight and a notepad. Look at tires, hoses, belts, chains, cutting edges, hitch points and structural welds. Write each problem on a list as you find it, with the part and a note. Winter is the best time to order parts and book repair work, because the dealer and the independent mechanic are less rushed than in March. Fix it now or at least schedule it.
Fluids and fuel
Change engine oil and filters before storage, because used oil carries acids that sit in the engine all winter. Check coolant for the freeze protection rating the manual specifies and test it with a hydrometer or test strips. Top off hydraulic fluid and check for water or discoloration. Fill the fuel tank to limit condensation, and add a fuel stabilizer or winter-blend treatment per the product label. Drain and flush sprayers, pumps and water lines completely, since a cracked pump is expensive. Follow the manufacturer's manual for each system, as fluid specs vary.
Batteries and electrical
Clean battery terminals and check the electrolyte level where it applies. Charge batteries fully, then either disconnect them or put them on a maintainer, depending on the manual. A discharged battery can freeze and crack in cold weather, while a charged one is much more resistant. Store batteries off bare concrete in a spot that stays above freezing if you can. Check lights, wiring harness connections and fuses, and spray connectors with a protectant. Remove portable electronics and monitors from cabs and bring them inside, where they are protected from cold, moisture and thieves.
Grease, rust and moving parts
Grease every fitting so fresh grease pushes out moisture. Coat exposed metal such as hydraulic cylinder rods, tillage shanks and plow points with a light oil or rust inhibitor. Retract cylinders where the manual says to, which protects the rods. Loosen belts and chains if the manual recommends it, and lower implements onto blocks to take weight off the tires. Check tire pressure per the sidewall or manual, and park machines out of the wet if you can. For a planter, empty the seed system and clean the meters thoroughly.
Pests and storage space
Mice love a warm cab and chew wiring. Block air intakes and exhaust openings with rags or covers, and mark them with a bright tag that reminds you to remove them in spring. Clear nesting material, and put out bait or traps in the building, keeping pets and children away from them. Seal gaps in the shed. If you store inside, keep machines away from stored grain and hay, which attract rodents. If you must store outside, cover with breathable tarps rather than plastic that traps moisture.
Close out the paperwork
Record hours at storage, service done, and parts needed in each machine's file. Take photos of anything worn. Check insurance coverage for stored equipment and ask your agent whether any storage conditions apply. List the work you want done by a mechanic and call early. Put a spring checklist on each cab door so the next person knows what to do before starting. For machines you will not use for a long period, check the manufacturer's long-term storage guidance. Local dealers and repair shops are listed by state in the directory on this site. Spend a rainy afternoon on this list in October and you will thank yourself on a cold morning in April when everything starts on the first try.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
