In short
- Inspect on a daily, weekly and seasonal schedule, and write every finding down.
- Check fans, sensors, drinkers and backup power first, since those failures hurt fastest.
- Test the alarm and generator under real conditions, and keep contractor findings and repairs in writing.
Set up the inspection routine
Think of this as a walk-through with a clipboard, not a one-time event. Pick a schedule you can keep: a quick daily check of ventilation, water and feed, a weekly mechanical check, and a deeper monthly or seasonal inspection. Write the date, who inspected, the barn or room, and what was found. If you have a veterinarian, ask what they want to see on the form, since they know which failures tend to show up in your type of operation. Follow the equipment manuals for service intervals and your integrator or buyer program if you raise pigs under contract. Keep every completed form in a binder or a folder on your phone. Paper that stays blank is paper that fails you.
Ventilation and temperature controls
Start with the fans. Check that each runs smoothly, that belts are tight, shutters open fully and blades are clean, since dust cuts airflow quickly. Look at inlets and baffles for blockage. Compare the controller settings with what your vet or the equipment manual recommends for the age of pigs in the room, and verify the thermostat or sensor reading against a separate thermometer. Sensors drift, and a sensor reading three degrees off can run a room too hot or cold for weeks. Test the alarm by simulating a high temperature, if the manual permits. Record temperatures at several points in the room, not just beside the controller. Replace anything that hums, rattles or runs hot to the touch.
Feed systems
Walk the feed line from bin to feeder. Look for wet or caked feed in bins and augers, bridging in hoppers, worn auger flighting and loose bolts on the motor. Check feeder adjustments by watching pigs eat: wasted feed on the floor means the gap is too wide, and empty troughs mean it is too tight. Calibrate feed drops according to the manual. Clean out old feed regularly, and be careful with mold in damp corners. If you use medicated feed, follow the label and your veterinarian on records and withdrawal, and keep the delivery tickets. Ask your feed supplier how they clean out bulk bins and trucks between loads. A short note about what was in each bin helps if there is ever a mix-up.
Water and drinkers
Water matters more than feed, so inspect it first. Test every nipple or bowl drinker by hand and check flow. The manual or your vet will tell you the target flow for each pig size. Catch water in a measuring cup for a set number of seconds and write down the number. Look for leaks, which soak bedding and floors, and for blocked or stuck drinkers. Check the height against pig size, and look at water lines, filters and any medicator. Flush lines on a schedule, especially after medicators. If your water comes from a well, ask your local Extension or health department about testing, and keep results with your records. Rules on water systems vary by state.
Power, backup and manure systems
Your fans and controllers need electricity, and a failure in summer can kill pigs within hours. Test the standby generator under load on a schedule from the manual, not just a quick start. Check fuel, oil, battery and the automatic transfer switch. Walk through what happens when power drops: do curtains drop or inlets open as designed? Inspect wiring for rodent damage and corroded connections, and have an electrician look at anything questionable. Check pit fans, gas alarms and manure pumps, and never enter a pit without proper training and equipment, since pit gases are dangerous. Check with your state department of agriculture and environmental agency about manure and permit rules, which vary by state.
Pens, flooring and what goes in writing
Finish with pens, gates, latches and flooring. Look for sharp edges, broken slats, loose rails and anything that cuts or traps a pig. Check scales, sorting boards and loading chute too. For repair work done by outside contractors or electricians, get a written scope, price and a note of what was found. Keep a list of repairs with a column for date completed. Sort items into three groups: fix today, fix this week, watch. Hand the oldest unresolved item to someone by name. Review the binder with your vet at least once a year, and look up your state in the directory for service providers.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
