In short
- Use rated chains and straps in good shape, with enough working load limit for the load.
- Tie down at the manufacturer's points and lock moving parts on the machine.
- Recheck the load within a few miles, and at every stop after that.
Start with the rules and the ratings
Tie-down rules for commercial and farm hauling come from federal and state transportation agencies, and some farm exemptions exist, but they vary by state and by vehicle. Confirm with your state department of transportation or highway patrol what applies to you. Look at the working load limit on each chain, strap, and binder, which is printed on a tag or stamped on the hardware. Do not use anything with a missing tag, cuts, knots, or kinks. The combined working load limit of your tie-downs should meet the minimum in the rules for the weight of the load, so ask your state for the specifics.
Prepare the trailer and the load
Check the trailer first: tires and air pressure, lights, brakes, hitch and safety chains, deck condition, and tie-down points. Make sure the tow vehicle is rated for the loaded weight. Load the machine so the weight sits properly on the trailer, usually with the heavier end forward as the trailer manufacturer recommends. Park on level ground, lower implements, set the parking brake, and shut the machine off. Remove or secure loose items like buckets, buckets of tools, and hoses. Lock articulating parts, such as loader arms and steering joints, as the manual advises.
Chains, straps, and the pattern
Attach tie-downs at the manufacturer's tie-down points on the machine when the manual shows them. Use chains for heavy tracked and wheeled machines, and use edge protection where straps cross sharp edges. Use at least four points on larger equipment, front and rear, pulled down and outward at an angle that holds the machine against forward, backward, and sideways movement. Tighten each with a binder or ratchet, then check them again. Do not use a chain's hook as a tie-down on a point not meant for it. Follow the specific rules for the weight and length of your cargo.
Secure the small parts
Lower and lock implement arms, fold and pin wings, and tie down booms, augers, and spouts. Strap loose tires and parts to the deck. Make sure tarps do not flap in a way that hides the lights or loosens the cover. Put slow-moving-vehicle emblems, flags, and lights in place for wide or long loads, and check the rules on oversize loads and escort requirements with your state, since limits for width, height, and length differ. Carry a spare tie-down or two, along with a tire iron and a few reflective triangles.
The walk-around and the first stop
Walk around the whole rig before you pull out. Check every chain and strap, and check the hitch coupler and safety chains. Drive a short way, then stop within the first few miles and check the load again, since straps settle and chains loosen. Recheck at each fuel stop. Watch the load in your mirrors for shifting. Allow more room for braking and for turns, and slow down on rough roads. Keep your paperwork, including permits, registration, and insurance cards, where you can find them. Ask your insurance agent how towing equipment on the road is covered.
Unloading and mistakes to avoid
Unload on level ground with the trailer attached to the tow vehicle. Release tension on binders slowly, since a loaded chain can snap back. Wear gloves and keep hands clear of the binder handle. Common mistakes include too few tie-downs, damaged straps, no edge protection, forgetting to check after the first few miles, and trusting the machine's brakes alone. Do not use a tie-down for something it was not made for. Replace worn gear instead of waiting for it to fail. Keep a written checklist in the truck and make everyone who hauls follow it.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
