In short
- Run the sprayer on clean water first and fix every leak and drip.
- Replace worn hoses, filters and nozzles, then calibrate at working speed and pressure.
- Test controls and sensors, and check safety gear and licensing before the first spray day.
Start With the Manual and a Water Test
Pull out the operator's manual and the service log. Fill the tank with clean water, not product, and run the machine in the yard before the first job. Watch for leaks at every fitting, hose and valve. Run each boom section, test the pressure and listen to the pump. A water test costs you a few minutes and a few gallons, and it shows problems that would otherwise appear in a field with a crop and a forecast. Write down what you find. Fix small drips now, since they become big leaks under pressure. Keep this season's checklist with last season's so repeated problems show up.
Pump, Hoses and Plumbing
Check the pump oil level and condition according to the manual, and inspect diaphragms or seals, which wear with abrasive products. Look at hoses for cracks, bulges and soft spots, especially at bends and clamps. Replace hoses that are suspect, since a burst hose sprays product on the operator. Check clamps, fittings, o-rings and gaskets. Clean or replace strainers and screens. Look at the agitation system and the jet agitators in the tank. Test check valves and the shut-off for drip when the booms close. Replace chemical-resistant gloves and respirator cartridges if you use them, and check the eyewash bottle and clean water supply.
Tank, Rinse System and Filters
Inspect the tank inside for residue, cracks and sediment, and look at the lid gasket, sight gauge and vents. Make sure rinse nozzles in the tank work. Flush the system and check the clean-water tank and hand-wash tank for algae or odor. If the machine was winterized with antifreeze, flush it out completely according to the manual and the product label, and dispose of the rinse as the label or your state agriculture department allows. Replace the filters with the right mesh sizes for your nozzles, since a screen finer than needed clogs and one too coarse lets debris through.
Boom, Nozzles and Calibration
Inspect the boom for sag, bent sections and loose hinges. Check nozzle bodies, caps and diaphragms. Replace tips that are worn or damaged, and check flow at each nozzle with a catch test. Calibrate the sprayer at the speed and pressure you expect to use, using gallons per acre equals gallons per minute per nozzle times 5,940, divided by miles per hour times nozzle spacing in inches. Check the pressure gauge and speed sensor. Look at boom height against the nozzle chart. Make notes on anything off. Our related guides on nozzle wear and boom height cover the details.
Controls, Sensors and Electrical
Turn on the rate controller, flow meter, GPS, section control and monitor, and check for software updates through your dealer. Look at wiring for chafing and corrosion. Test each section valve and the master switch. Check the flow meter calibration number and the speed source against a measured distance. Test lights, work lights and mirrors. If you use auto-steer or boom-height sensors, test them on a pass in a field or yard. Backup your settings and field data before updating anything. If a part is on back order, order it early and ask the dealer what the lead time is.
Safety, Records and Paperwork
Check the first-aid kit, fire extinguisher, spill kit and personal protective equipment. Review product labels for required protective gear and re-entry rules. Pesticide applicators may need a license, and the requirements vary by state; confirm with your state department of agriculture. Plan where the sprayer will be filled and washed, away from wells and water. Keep application records with the product, rate, date, field, wind and equipment. If you hire a custom applicator, ask whether the sprayer follows a checklist like this, and ask for their licensing information and insurance. Look up your state in the directory for sprayer repair and application services.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
