In short
- Clean right after spraying, following both the previous and next product labels.
- Rinse three times with about ten percent tank volume, flushing booms and hoses each time.
- Apply rinsate only as the label and state rules allow, and record every cleanout.
Why Cleanout Matters
Some herbicides are active at tiny concentrations, and a residue from one job can injure a sensitive crop in the next. Dried product builds in corners, hoses and boom ends, and then releases when new liquid hits it. The damage often looks like random streaks or patches that appear days later, and tracing the cause is difficult. Cleanout also protects equipment, because some residues attack seals and plug screens. Always read the label of the product you just sprayed and the next product. The label sets the cleanout steps, and the label is the law. Cleaning rules and disposal rules vary by state, so check with your state department of agriculture.
Do It Right Away
The best time to clean is at the end of the job, before residue dries. Spray out the remaining mix on the treated field if the label allows, within the labeled rate. Then rinse right there or at a proper wash site. Do not leave the sprayer dirty overnight or over a weekend unless you have no choice. Wear the protective gear listed on the label, since rinse water is still pesticide. Keep a hose with a backflow preventer or an air gap so you never put a hose into a tank and risk pulling product back into a water source. Rinse the outside, especially the boom and wheels, to avoid tracking product around.
The Triple Rinse Routine
Fill the tank with clean water to about ten percent of its capacity, or as your manual says. Agitate, flush the boom, hoses and nozzles, and spray the rinse out on a labeled site. Repeat three times. A quick example shows why it works: suppose a 1,000 gallon tank holds 3 gallons of residual mix after spraying out. A 100 gallon rinse dilutes it to about 3 parts in 103, or around 3 percent of the original strength. Three rinses cut that to a tiny fraction of one percent. Remember that this only works if the water reaches every part, including the boom ends and the filters.
Cleaning Agents and Special Products
Some products need more than water. Labels may call for a tank cleaner, household ammonia or a detergent for certain herbicides, and they may warn against mixing cleaners with other chemicals. Follow the label exactly, including contact time and any warnings about ventilation. Soak screens, strainers and nozzle tips in a bucket, and clean them by hand, using soft brushes. Check the label of any cleaner for compatibility with rubber seals and hoses. If you are not sure, call the manufacturer's technical line or your dealer. Do not guess when the next crop is soybean, vegetable, potato or other sensitive plants. Ask your agronomist about a bioassay, such as growing test plants in rinse water.
Dispose of Rinsate Properly
Rinse water must go somewhere. Many labels allow spraying it on the treated crop or site, within label rates, and some states allow it on fallow ground. Do not dump it near wells, ditches, ponds or drains. Consider a rinse pad with a sump or a mobile system that collects rinsate. Rules on wash pads, storage and disposal differ by state and sometimes by county, so call your state department of agriculture or Extension before you build one. Keep the filters and any solids as the label directs. Never pour rinsate in a field drain tile intake.
Keep a Cleanout Record
Write down each cleanout: date, operator, last product, next product, number of rinses, volume, cleaner used, location of rinsate application and filters cleaned. Note anything unusual, such as a stuck screen or foam. If a custom applicator will use your sprayer or you use theirs, ask for the cleanout record of the last jobs before your crop. Keep the sheet with your application records. Look up your state in the directory for sprayer cleaning and custom application providers.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
