In short
- Do the big repairs in winter, and order parts before the season rush.
- Grease, check belts and look over knives every day of the hay season.
- Wash, grease and store machines under cover after the last cutting.
Why a calendar helps
Hay machines work hard for a short time, then sit. Most failures come from the same causes: worn knives, dry bearings, loose chains and tires, and rodents in the shed. A calendar puts the jobs in the slow months, when parts can be ordered and a shop has time. Build it around your own manuals, since each baler, mower and rake has its own intervals, torque values and grease points. Keep a log of what was done and the hours or bales so you can see wear patterns. Check your equipment dealer for parts lead times, because in a wet June they can stretch.
Winter shop work
After the first hard freeze, pull each machine inside and clean it, then do the big jobs. Inspect the mower-conditioner knives, guards and cutter bar, the conditioner rolls and the drive belts. Check the baler knotter or net wrap system, the pickup teeth and belts, the bearings and the chain drive. Look for cracks and rust. Order parts now, replace tires or tubes, and repaint any bare steel. Winter is also the time to look at the manuals again and update your checklist with anything you learned last season.
Early spring and pre-season
A few weeks before the first cutting, grease every fitting and change gearbox oil per the manual. Put on fresh knives and set the sickle or disc spacing. Check the tractor too, including hydraulics, tires and PTO shaft shields. Run each machine for a few minutes with nobody near it, and listen for noise. Adjust chain and belt tension. Test the baler tie, and run a few practice bales to find trouble before the hay is ready. Check lights and slow moving vehicle signs.
During the season
Short daily checks catch most problems. Look over knives and guards on the mower, grease fittings on the schedule, and check belts and chains at the start of each day. Clear wrapped twine and crop from rollers and pickup, with the machine off and the key out. Watch for oil leaks and hot bearings, and keep a few spare parts in the truck, such as knives, bolts, a belt, shear bolts and twine or net wrap. A spare you never use costs less than a day of waiting.
After the last cutting
Wash the machines, because wet hay residue holds moisture and starts rust. Grease them again so fresh grease pushes out moisture. Lower or support machines that should not sit under spring load, and release belt tension as the manual advises. Drain and store fuel according to the label if equipment will sit. Note the worn parts, and put them on a list for the winter. Store under cover, and keep mice out of wiring and cabs.
When to hire the work
If you cannot do a repair, find a shop that works on hay equipment before the season. Ask for an estimate in writing, a completion date and how they handle warranty. Check the manufacturer warranty before any outside work to avoid voiding it.
Safety and record keeping
Make safety part of every task. Shut off the engine, remove the key and wait for moving parts to stop before reaching into a baler, rake or mower, and block raised machines with stands rather than hydraulics alone. Keep guards and PTO shields in place. Write each service in a log with the date, the work done, the parts used and the hours or bales baled. After two or three seasons, you will see which parts wear first, and you can stock them ahead. Store manuals with the log, and take photos of belt routing and chain paths before you take things apart, so you can put them back the right way.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
