In short
- Do the weight arithmetic for the truck, the trailer and the load before every haul.
- Inspect the coupler, chains, tires, brakes and the floor, not just the lights.
- Check state transport rules and keep a written inspection and repair log.
Know your weights first
Safe towing starts with numbers on paper. Find the trailer's gross vehicle weight rating on the plate, usually on the tongue or frame, and the tow vehicle's towing and tongue weight limits in its manual. Weigh the empty trailer if you can. Then do the arithmetic. If the rating is 14,000 pounds and the empty trailer weighs 5,000, the load limit is 9,000 pounds. Six cows at 1,300 pounds weigh 7,800 pounds, which fits with 1,200 to spare. Seven would be 9,100 and exceed the limit. Check the truck too, since the lower limit between truck and trailer rules, and follow the manufacturer manuals.
Hitch and coupler
Look at the coupler for cracks, wear and a latch that closes fully. Make sure the ball size matches the coupler stamp, because a mismatched ball can pop loose. Check the ball for wear and the hitch for bent or cracked parts. Cross the safety chains under the tongue and hook them to the truck frame, not the bumper, with enough slack to turn but not so much they drag. Check the breakaway cable and its battery, and connect it to the truck, not the hitch. Pin or lock the coupler, and give the trailer a pull test before you leave the yard by trying to lift the tongue off the ball.
Tires, wheels and brakes
Check tire pressure cold, against the number on the tire sidewall or trailer placard. Look for cracks, bulges, uneven wear and tires old enough that the rubber has hardened, even with good tread. Trailer tires often age out before they wear out; ask a tire dealer how to read the date code. Tighten lug nuts to the manufacturer's torque and recheck after the first miles on any new wheel. Test the brake controller and the brakes on a flat piece of road. Have bearings greased or inspected on the schedule in the axle manual. Carry a spare that fits and a jack and lug wrench that work.
Floor, walls and gates
The floor is the part you can't see from above. Probe wood floors with a screwdriver at the edges and under mats for soft spots, and lift mats at least once a season. Check aluminum floors for cracks and steel for rust-through. Look at walls, roof and dividers for sharp edges and bolts that stick out. Test every gate, latch and slider and make sure each one closes tight and cannot be bumped open. Keep the floor from being slick with fresh bedding or sand where the manufacturer allows it. A stock trailer floor that fails on the highway is the worst kind of surprise, and nobody has ever said they saw it coming.
Lights, electrical and road gear
Hook up the trailer and test brake lights, turn signals, running lights and the connector on the truck end. Check the wiring for chafing or dangling plugs, and clean corroded contacts. Keep spare bulbs and fuses. Carry reflective triangles or flares, a fire extinguisher, a flashlight, gloves, a knife for cutting rope, a first aid kit and a halter. Many states require specific equipment, and rules on licensing, inspection and commercial driver requirements vary, so check with your state department of transportation and your state agriculture department.
Loading, driving and animal care
Load calmly and keep the weight balanced, with slightly more ahead of the axle than behind, and follow the manufacturer manual on tongue weight. Do not overload for a short trip, since trailers fail on short trips too. Allow extra stopping distance, take turns wide, and check on the animals at the first stop within a short distance and again at intervals. Give animals water and rest on long hauls according to the animal welfare guidelines for your species. Keep a written log of inspections, repairs and tire changes, and fix any defect before the next load.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
