In short
- Catch seed over a measured number of wheel turns, then convert the catch to pounds per acre.
- Retest whenever seed species, lot or treatment changes.
- Confirm the rate in the field and keep a written record per drill.
Start with the manual and the seed
Every drill has a calibration chart in the operator manual, but the chart is built for average seed. Small grains, cover crop mixes, clovers and grasses all flow differently, and a seed lot treated with a coating will not flow like bare seed. Calibrate with the seed you are actually going to plant. Fill the hoppers at least a third full, because a nearly empty box can meter differently than a full one. Set the gate, the seed cup and the drive gear to the chart setting for your target rate, then test. Make notes of the seed species, variety, lot and any treatment. You will thank yourself when the same lot comes back next year.
The jack-up method
Jack the drive wheel off the ground, or lift the whole drill if it is ground driven and the manual allows. Mark the wheel, hang a catch bag or tray under a few seed tubes, and turn the wheel a set number of revolutions. Measure the wheel circumference, not just the diameter. Say the circumference is 5 feet and you turn it 20 times. That is the same as driving 100 feet. A 10 foot drill covers 1,000 square feet in 100 feet, which is 0.023 acre, since 1,000 divided by 43,560 is about 0.0230. If your target is 60 pounds per acre, you want 60 times 0.023, or about 1.38 pounds across the whole drill.
Reading the result
Collect seed from every opening, or from a set number of tubes and scale up. Say you collect 1.5 pounds from the whole drill. Divide by 0.023 acre and you get about 65 pounds per acre, which is a little high against a 60 pound target. Close the gate a notch and test again. Repeat until you are within a couple of percent. Weigh the catch on a scale that reads in grams or tenths of an ounce, and note that a kitchen scale is enough for small tests. Also check each opening. If one tube delivers far less than its neighbors, look for a plugged cup, a bent agitator or a worn drive.
Check it in the field
The bench test assumes no wheel slip. In loose or wet ground the drive wheel slips and the drill underplants. So after you set the rate, drive a short distance at planting speed, measure the distance and count seed in a row. For small grains, dig or scratch a few feet of row and count seedlings later against your target stand. Look at seed depth and soil closure too, because residue, hardpan and moisture change how the openers perform. Your Extension office or seed supplier can give you stand targets for your crop and area.
Keep a record
Write down the date, seed lot, drill, gate setting, wheel revolutions, pounds caught, calculated rate and the final adjustment. Add the field and the soil conditions when you drilled it. If a custom operator drills for you, ask for the same numbers and when they last tested. Rates, seed treatments and planting dates vary by crop and region, so follow the label and local recommendations.
Mistakes to avoid
The common ones are skipping the test because the chart looked right, forgetting to recalibrate when the seed lot changes, and testing at the wrong gear. Calibrating a half-worn drive is another. Wheel slip is a good reason to recheck in the field.
Different seed, different test
Small seed such as clover or native grass flows in tiny amounts, so a one-pound catch is too coarse. Run more revolutions, or turn the wheel for a full 1/10 acre equivalent, and weigh in grams. Mixed seed can separate in the box as it vibrates, with heavy seed sinking and light seed riding on top. If you drill a cover crop blend, test each species in its own cup when the drill has separate boxes, and check the mix again halfway down the hopper. Ask your Extension office or seed dealer for seeding rates by species, and adjust for seed quality as the label shows.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
