Farm service guides and a state-by-state directory for farmers and ranchersA farm.FM network site · Farm news →
AgServicesDirectoryWho to call, state by state
Home › Guides › Worksheets, Checklists & Calibration Guides › Poultry House Equipment Checklist

Poultry House Equipment Checklist

A good checklist keeps feeders, drinkers, fans and controls working through a flock cycle, and gives you a record to show your integrator or buyer.

Worksheets, Checklists & Calibration Guides3 min read647 words

In short

  • Split the work into a daily walk and a deeper between-flock inspection.
  • Check water pressure, drinker height, feed lines, fans, heaters and sensors against the manuals.
  • Test the generator and alarm under real conditions and keep dated records.

Between flocks and every day

There are two lists. One is the quick daily walk. The other is the deep inspection done while the house is empty. On the daily walk, look at the water lines and drinkers for leaks and clogs, the feed lines and pans for jams, the fans and inlets for proper operation, and the temperature and alarm readings at the controller. Listen as well as look, because a belt squeal or a motor rattle tells you something before a failure does. Between flocks, you have time to take things apart, so schedule it. Contract growers should read the integrator's equipment and biosecurity requirements, since they vary by company and you need to follow them.

Drinkers and water

Check the water pressure at the regulator and at the end of each line, since the correct pressure depends on the drinker type and bird age. Look at the manufacturer manual for the numbers. Flush the lines between flocks, and record the water meter reading so you notice any change in use. Adjust drinker height as birds grow, and write down the heights you use. Wet litter under a drinker is a clue to a leak or a bad height. Replace worn nipples or cups before they drip. Test the water supply per your integrator or local health guidance, and keep the reports.

Feeders and augers

Check feed pans or troughs for cracks and sharp edges, the line height, the auger for wear, and the motors and the hopper level sensors. Run the system empty and listen. Confirm that the last pan on each line fills, since a gap there means birds at the end are short on feed. Grease where the manual says and record the date. Keep a spare motor or gearbox, or know where to get one fast. Calibrate any scales or feed weighers against a known weight.

Ventilation, heat and cooling

Test each fan by hand with the power locked out. Check belts, shutters, louvers and the guards. Clean dust from blades, since it cuts airflow. Look at inlets and curtains for tears and gaps. A house that leaks air is hard to control, so check tightness the way your equipment dealer or Extension poultry specialist recommends. Inspect heaters, burners and thermostats, and check the gas lines for leaks per the manufacturer and local code. Check cooling pads and pumps and clean the water sump. Verify that the controller sensors read correctly by comparing them to a good thermometer in the same spot.

Power, alarms and backup

This is the item growers skip, and it is the one that costs flocks. Test the backup generator under load, check the fuel and the transfer switch, and test the alarm by simulating a power failure or high temperature. Make sure the alarm calls the phone number you actually answer. Replace batteries on schedule. Rules on generators, fuel storage and electrical work vary, so confirm with your electric supplier and a licensed electrician.

Mistakes to avoid

Skipping the empty-house inspection, using a house as a storage shed and letting the alarm contact list go stale are the common ones.

Records worth keeping

Keep a binder or a clipboard with the checklist, repair dates, fan and controller settings, water meter readings, generator test results and the manuals for each piece of equipment. Add the phone numbers of your electrician, your equipment dealer and your integrator's service rep. Note the model and serial numbers of the major items, so ordering parts is quick. These pages also help when you apply for a loan on new equipment or when a buyer or auditor asks how the houses have been maintained.

Find providers near you

Pick your state to see vets, custom operators, dealers, elevators and other farm services.

Keep reading