Farm service guides and a state-by-state directory for farmers and ranchersA farm.FM network site · Farm news →
AgServicesDirectoryWho to call, state by state
Home › Guides › Worksheets, Checklists & Calibration Guides › Forestry Equipment Safety Checklist

Forestry Equipment Safety Checklist

Woodlots and timber work injure people every year, and most of those injuries start with equipment or habits. Use this list before the saw or skidder starts.

Worksheets, Checklists & Calibration Guides3 min read680 words

In short

  • Wear full protective gear and check the saw brake and chain every time.
  • Plan the escape path, and never work under hung trees or near wires.
  • Verify insurance and licensing before any logger sets foot on the land.

Check your protective gear first

Before any cutting, put on the gear that protects you from the usual injuries. That means a hard hat, eye protection, hearing protection, cut-resistant chainsaw chaps or pants, sturdy boots with cut protection if you can get them, and gloves. A bright shirt helps others see you. Gear that hangs in the shed does nothing. Check helmets and chaps for damage, because a chain cut or a hard blow can weaken them. Review the manufacturer manual on each piece of gear, and read the label on chaps for the standard they meet.

Chainsaw inspection

Look over the saw each time you fuel it. Check the chain brake, the chain catcher, the throttle lockout and the handguards. A chain should be sharp and correctly tensioned, and the bar should be straight with a clear groove. Use fresh fuel mixed to the manual, since the wrong mix can damage an engine. Refuel on bare ground away from sparks, and move at least a few feet from the fueling spot before starting. If the brake or any safety part fails, park the saw until it is fixed.

Tractor, skidder and winch checks

If you drag or hoist logs with a tractor, check that the rollover protective structure and seat belt are in place, because tractors without them are a leading cause of farm deaths. Look at the operator guard, the grapple or tongs, the cable or chain, and the winch brake. Replace frayed cable, since it can snap with force. Do not exceed the rated load, and keep the logs low and the load tight. Wear the belt when the tractor has a rollover structure. Do not use a tractor on slopes that the manual says to avoid.

Plan the tree and the escape

Before a cut, look up and around. Check for dead limbs, leaning trees, wires, trails and other people. Clear a path to retreat, at about a forty five degree angle away from the expected fall, and tell everyone where you will be. Keep other workers at least two tree lengths away. Hung trees and spring poles are where people get hurt, so do not walk under or try to shake a hung tree down. Pull it with a winch or call someone trained.

Training, rules and weather

If you have never felled large trees, take a course from your state forestry agency, Extension or a trade group. Workplace rules for logging vary by state and by whether you have employees, so confirm with the state agency and OSHA what applies to you. Do not cut in high wind, ice or when you are tired. Carry a charged phone or radio, and a first aid kit with a bleeding control item. Tell someone the area you are working in and when you plan to come out.

Hiring a logger

If you sell timber or hire clearing, ask the logger for proof of insurance, workers compensation where required, and the state license or registration if your state has one. Get a written contract covering the boundaries, the trees included, stream and road protection, cleanup and payment. Have a forester you trust look at it.

Emergency plan and first aid

Write down the plan before work starts. Know the address or coordinates of the work site, so you can tell an emergency dispatcher where to go, and mark the nearest road access. Check phone signal, because many woodlots have none, and carry a two-way radio or satellite device if needed. Keep a first aid kit with a tourniquet and bleeding control dressing, and learn how to use them through a Red Cross or similar course. Never work alone in heavy timber if you can avoid it. If someone is hurt, shut off the saw, call for help first, then give care, and have a second person meet the ambulance at the road.

Find providers near you

Pick your state to see vets, custom operators, dealers, elevators and other farm services.

Keep reading