In short
- Wear parts, bearings and hoses cause most tillage breakdowns, so inspect them first.
- Follow the manual for torque, grease and pressure, and measure parts instead of guessing.
- Level the machine and dig test holes before committing to a full day of tillage.
Start with a clean machine
You cannot inspect what you cannot see. Wash or blow off the frame, shanks and gangs before you look closely, since dried mud hides cracks and leaking cylinders. Park the tool on level ground, lower it onto blocks, and relieve hydraulic pressure before anyone crawls underneath. Lock out the tractor. Walk the whole machine once without a wrench in your hand and look for bent frames, cracked welds near hitch points and wing hinges, missing pins and anything that looks newly rubbed bright. Take phone photos of anything questionable so you can show a dealer or welder exactly what you found. Cracks usually start small and run during the first heavy pull.
Ground-engaging wear parts
Points, sweeps, shovels, disk blades and coulters are the parts that actually do the work, and they wear out first. Measure them against the new-part dimension in the manufacturer manual or parts book. A worn point increases draft, which costs fuel and slows you down. A disk blade that has lost much of its diameter will stop cutting the way it should and can change the gang angle on the whole tool. Replace parts as sets so one side is not pulling differently. Check bolts and mounting hardware, and replace any that are stretched or rounded. Keep the old parts in a pile until the new ones are on, because it settles arguments about size.
Bearings, hubs and grease points
Gang bearings and wheel hubs live in dirt and water. Spin each gang by hand or with the tool lifted a little and listen for grinding. Feel for play by pushing and pulling on the blade. Look for grease leaking from seals, which can mean a seal has failed, or for dry, rusty grease, which means water got in. Grease every fitting listed in the manual with the grease type it specifies and note which fittings have been broken off. Replace missing fittings rather than leaving a dry bearing. Cheap bearings changed in the shop in October cost much less than a gang seized in a field in the rain.
Hydraulics, tires and the hitch
Inspect hoses for cracking, bulges or bare wire, and check every fitting for weeps. Replace damaged hoses rather than taping them. Check cylinders for rod pitting and seal leaks. Test wing fold and depth control through a full cycle with the machine in an open area. Inspect tires or wheels, set pressures to the manual, and check lug nuts. Examine the hitch pin, clevis and safety chain for wear, and confirm that lights and the slow-moving vehicle emblem are working if you travel on public roads. Road rules for width and lighting vary by state, so confirm with your state agency.
Settings before you hit the field
Level the tool front to back and side to side with it sitting in the field, since a machine run nose-high or nose-low will leave uneven depth and unequal wear. Set working depth according to what you are trying to accomplish, and check it at several spots rather than trusting the gauge. Verify shank spacing and trip pressure against the manual. Run a short test pass and dig a few spots to check depth, residue burial and how smooth the surface is. Adjust, then test again. Rushing this step costs more than the hour it takes.
When to call a shop
A welder can repair many frame cracks, but the wrong repair on a stressed area can fail again, so ask whether the shop is familiar with the tool's steel and design. Get a written estimate for any major work, with parts and labor separated, and ask how long it will take, since a good price on a repair that finishes after tillage season is not a good price. Look up your state in the directory for repair and welding services near you.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
