In short
- Set boom height from the nozzle chart for your angle and spacing, not by eye.
- Measure at both ends, center and folds, with the tank about half full.
- Record every reading and fix sag, twist or worn hinges before they cost you yield.
Why Boom Height Matters
Each nozzle sprays a fan, and neighboring fans must overlap to give even coverage. If the boom is too low, the fans do not overlap enough and you get streaks. If it is too high, the overlap is too much, coverage is uneven in another way, and the spray is more exposed to wind drift. The right height depends on the nozzle angle and the nozzle spacing. As a rough example, many 110 degree nozzles on 20 inch spacing call for a boom around 20 inches above the target, while 80 degree nozzles need to be higher. Those are general figures, so use the nozzle maker's chart and your sprayer manual as the final word.
What to Measure
Park the sprayer on level ground with the tank about half full, since a full tank and an empty one sit differently on the suspension. Measure from the nozzle tip to the target, which is the top of the crop canopy or the ground for preplant work, at several points across the boom: both ends, the center and both folds. Record each reading. Check that all nozzles are the same type, angle and size, facing the same direction, and spaced evenly. Check that nozzle bodies are not bent or loose. Measure the spacing with a tape between several pairs. Note the crop stage, since target height changes as the canopy grows.
Check Boom Level and Squareness
Sight along the boom from behind the sprayer and from the side. Look for sag in the tips, twist, bent sections and a boom that tilts up or down. Walk to each wing and look for loose hinges, worn bushings or hydraulic leaks. With the boom folded out and on flat ground, measure from the ground to the same point on the left and right wings; if the difference is more than an inch or two, ask your dealer how much the manual allows. Check that breakaway mechanisms return to position after a hit. Record any difference and what repair was made.
Height Control and Terrain
Automatic boom height systems use sensors to follow the ground or the crop. Test them in the field at working speed, since a sensor that works in the yard may lag on rough ground. Check the sensors for mud and damage and confirm the calibration steps in the manual. Watch where terraces, waterways and field ends make the boom whip. Reduce speed in rough areas, because boom bounce changes coverage and can send the tips into the ground. Record the speed at which your boom stays stable and note any places where manual control is better.
Drift, Pressure and Speed
Boom height is only one part of drift control. Higher boom, higher pressure and faster travel all increase drift risk. Read the herbicide or insecticide label for restrictions on nozzle type, droplet size, wind speed, boom height and buffer zones, since the label is the law. Rules for applications near sensitive crops, water and homes vary by state; check with your state department of agriculture. Record wind speed and direction, temperature, humidity and nozzle settings on each spray day. If you hire a custom applicator, ask for the same record and keep it with your invoices.
Making the Form Useful
Keep one page per sprayer. Date, operator, crop and stage, nozzle type, spacing, target height, measured heights at each point, level readings, repairs and notes. Fill it out before spring starts, again when you change nozzles, and after any boom strike or hard use. A repeated problem such as the right wing always running low tells you something is wearing, and you can fix it before it damages a crop. Photograph a tape against the nozzle for a quick visual record. Look up your state in the directory for sprayer repair and custom application services.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
