In short
- Verify licenses and permits with the issuing agency, not with the installer.
- Get the bid to say what happens with rock, water and poor soil.
- Keep an as-built map and protect the drain field from equipment.
Licensing comes first
Septic installers are usually licensed or certified by the state or the county health department, and the rules differ widely from one state to the next. Ask for a license number and check it with the issuing agency before you sign. The same goes for electricians and plumbers. A tractor operator who digs ditches is not necessarily qualified to design a drain field. If a person says no license is needed on a farm, ask which agency told them that, and call that agency yourself. An unpermitted system can cost you later when you sell, borrow or have a failure.
Soil, site and system design
Septic design depends on soil, slope, groundwater, the number of bedrooms or fixtures, and distance from wells, ponds and property lines. The county health office or a licensed designer typically runs a soil evaluation or percolation test before a permit issues. Ask who does that work and what it costs, since it often falls outside the installer's price. Ask what system type the site calls for and why. A conventional gravity system, a mound and a pressure-dosed field have very different costs. Do not let anyone place a drain field where you may want a shop, a pond or a driveway later. Ask whether the designer left room for a replacement field, since many places require reserve area, and the county can tell you the rule.
Utilities beyond the house
Farms add loads that homes do not: shop welders, grain dryers, well pumps, irrigation, barn fans and frost-free waterers. Ask your electric utility about service size, transformer limits and line extension rules, since the utility often controls the timeline and sometimes the cost. Ask your installer to size wire and breakers to the equipment manuals and local electrical code. For water lines, ask about burial depth for your frost line, which varies by place, and about shutoffs and drains. Call the free one-call utility locator service in your state before anyone digs, and keep the ticket number.
Permits and inspections
Permits for septic, wells, electrical and plumbing are usually separate, and inspectors often have to see the work before it is covered. Ask the installer which permits apply and who pulls them. Ask when inspections will happen and whether the crew will leave trenches open for the inspector. Covering a drain field before inspection can mean digging it up again. Keep copies of every permit, approval and as-built drawing. Rules vary by county, so confirm with the health department and building office rather than relying on the installer alone.
Pricing and what can go wrong
Underground work comes with surprises: rock, high water, old buried lines, buried debris. Ask how the bid handles rock or unsuitable soil and whether those costs are extra, by the yard or by the hour. Ask for a written scope that lists pipe size, tank size and material, the distribution method, backfill and final grading. Compare bids by those items, not by the bottom number. Ask about restoring pasture or crop ground, including topsoil handling and compaction. Heavy equipment running over wet ground can cost you yield for years.
Maintenance and records
After installation, ask the installer to explain pumping intervals, what should never go down the drain, and how to find the tank lids and the field. Ask for a written care sheet and an as-built map showing tank, lines and field locations. Mark the field so equipment does not drive over it. Livestock wash water and chemical rinse water should not go into a household septic system, so ask the health department what is allowed. Keep the paperwork with your farm records. Look up your state in the directory for licensed installers and utility contractors.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
