In short
- Confirm a legal outlet and check wetland rules before any pipe goes in.
- Ask about grade, depth, spacing and the grade control system the crew will use.
- Demand an as-built map and check the outlet after heavy rain.
Decide if tile will pay
Not every wet field needs tile. Ask your Extension office, soil survey and conservation district about soil type, water table and outlet. Tile pays best on soils that stay wet and can drain to a legal outlet. Without an outlet, there is no drainage. A drainage design should come from a survey and soil data, not guesswork. Compare the cost with expected yield gains using your own records and your lender's figures. Rules and cost share vary by state and program, so check before you spend money.
Legal outlets, wetlands and neighbors
Tile outlets often cross other land, and that raises legal questions. Drainage law differs a lot between states. Check with your county drainage board, soil and water conservation district or an attorney about outlet rights, drainage districts and assessments. If wetlands exist on the farm, USDA rules on wetland conservation and farm program eligibility may apply, so contact your NRCS office before installing anything. Talk to neighbors who share the outlet. Get any agreements in writing.
Design: spacing, depth and grade
A designer looks at soil permeability, depth to restrictive layers, crop and slope to set tile depth and spacing. Tighter soils need closer spacing. Grade matters because water has to keep moving. As a simple example, a fall of one foot over 1,000 feet is 0.1 percent grade, which is a common minimum on flat ground, though the right minimum depends on pipe size and the design standard you follow. Ask the contractor what grade they plan and how they check it. Ask about pipe size, main lines, surface inlets, blind inlets, and the outlet protection.
Equipment and installation
Most installers use trenchers or plows guided by laser or GPS grade control. Ask what control system the crew uses and how they check depth during work. Ask what pipe they install, whether it is corrugated plastic, solid or perforated, what filter or sock is used in sandy soils, and how connections are made. Trenching in wet ground is hard, so ask about timing. Ask how they handle crossings of old tile. Have them mark and map existing lines. Ask how topsoil is handled, and how they repair damage.
Pricing and the contract
Tile is usually priced by the foot, with extra for mains, inlets, boring and outlet work. Compare quotes line by line: pipe type and size, depth, spacing, fittings, inlets, outlet, restoration and mapping. Ask who pays for permits and design. Get references and visit older installations. Confirm insurance, including workers' compensation. Ask what happens if the crew breaks existing tile or hits unmarked utilities. Call the underground locating service before digging, and get a written schedule with a payment plan tied to progress.
Mapping, inspection and records
Insist on an as-built map showing tile lines, depth, grade, inlets and outlet location, ideally with GPS coordinates. This map is worth money later when you repair, expand or sell. Inspect the outlet after installation, and check it again after the first heavy rains. Look for wet spots, sinkholes at joints and sediment in the main. Keep the map, invoices and design with your farm records. Pay the last portion after the map and inspection are done. Ask who will be on the machine and who will be watching the grade. A good operator on a bad day still needs a second person with a rod or a receiver checking depth along the run. Ask how the crew handles a soft spot, a rock or a sand pocket in the trench, and what they do when they find an old clay tile that still runs. Write the answers into the agreement so you are not guessing later. Also ask about the warranty on materials and workmanship, who handles repairs when a joint fails and how soon they will come out.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
