In short
- Match the fence type to the livestock and the terrain, not to the contractor's habit.
- Corner and end braces decide how long the fence lasts, so ask how they are built.
- Verify boundary lines and state fence law before posts go in, and pay in stages.
Know what you need the fence to do
Before you call anyone, decide what the fence has to hold or keep out. Cattle, horses, sheep, goats, hogs, deer and boundary lines each call for something different. Woven wire holds sheep and goats, high-tensile smooth wire suits cattle over long runs, board or rail fence suits horse pens, and electric wire can work as a cheap inner fence. A contractor who recommends the same fence for every animal is selling what they build, not what you need. Tell them stock class, expected stocking rate, terrain and whether the fence is permanent. Ask what they have built for your livestock before and whether you can look at it.
Posts and braces decide everything
Wire is cheap compared with the labor of fixing a leaning corner. The strength of a fence lives in the corner and end assemblies, so ask how they build them. Ask post diameter, depth and whether posts are driven or set in drilled holes. Ask about the brace design and how they tension the wire. Line posts are spaced by wire type and terrain. As a plain example, a quarter mile is 1,320 feet, so posts every 12 feet make 110 spaces, which means 111 line posts before you add corners and gates. Spacing that is wider requires stays or stronger posts. Check the plan against the wire manufacturer's guidelines.
Pricing, bids and what to compare
Fence is usually priced by the foot, with corners, gates and tough ground priced separately. Rock, clay, timber and steep slopes slow a crew down. Ask whether the bid covers materials, clearing the fence line, post hole drilling and cleanup. Get written bids from at least three contractors, and make sure each lists the same wire, post size and spacing. If you supply the materials, ask whether the contractor stands behind the work. University Extension offices sometimes publish fence cost estimates and custom-rate surveys, which give you a sanity check. Prices vary by region and change with steel and lumber markets, so use those figures as a rough guide only.
Property lines, easements and neighbors
Fence on the wrong side of the line is expensive to move. Find your corner pins or hire a licensed surveyor if the boundary is in doubt. Many states have fence laws that spell out how neighbors share costs and upkeep, and rules differ widely, so confirm yours with your county Extension office, the state department of agriculture or an attorney. Call the underground utility locating service before posts go in. Tell neighbors before work starts, and talk about gates and shared water. A short note on a shared fence agreement, signed by both parties, can save a lot of trouble later.
Contract, insurance and warranty
Put the scope in writing: footage, materials, spacing, gate locations, schedule, payment terms and who clears the line. Ask for a certificate of liability insurance, and ask about workers' compensation for the crew. Get the warranty in writing, with a clear statement of what it covers. A one-year workmanship warranty is common but terms vary, so read the paper. Ask what the contractor does if a brace fails or posts heave after the first wet spring. Pay in stages tied to finished work instead of paying the whole thing at the start.
Inspecting the finished fence
Walk the line with the contractor. Push on corner posts and look for movement. Check that wire is tight and evenly tensioned, that staples are not driven so hard they pinch the wire, and that gates swing and latch without dragging. Look at the fence line for stumps, loose wire and trimmed brush. Check electric fence grounding if it applies. Take photos and keep the receipt for wire and posts so you know what was used. After a few months, walk it again.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
