In short
- Decide what the building will hold, and measure your biggest machine before you pick door sizes.
- Check zoning, permits and codes with the county before you sign anything.
- Compare bids on identical plans, put every change in writing and keep lien waivers.
Start with the job the building must do
Write down what goes inside: machinery, livestock, grain, hay, a shop, or a mix. The answer sets width, height, door size, floor type, ventilation and power. Measure your biggest machine with every attachment folded and unfolded, then add room to turn and walk around it. A combine that fits through the door with two inches to spare is a door you will regret. Think about the next machine, not just the current one, because equipment tends to grow. Decide whether the building needs heat, water, floor drains, or an insulated envelope. Changes made on paper are cheap and changes made after the concrete cures are not.
Zoning, permits and codes
Agricultural buildings are often treated differently from houses, but not everywhere and not for every use. A structure that holds livestock, stores chemicals, houses workers or has electrical service may need permits or inspections even where a plain hay shed does not. Setbacks from roads, property lines, wells and streams apply in many counties. Call the county zoning or building office early and ask what an agricultural exemption covers in your area. Check with your insurance agent and lender too, since they may require plans or inspections. Rules vary by state and county, so confirm locally before you sign a contract.
Choosing and vetting a builder
Ask for references from farm jobs finished at least a couple of years ago, and drive out to see them. Ask the owners how the building has held up, how the builder handled changes and whether the final cost matched the quote. Confirm the contractor is licensed where licensing is required, and ask for proof of liability insurance and workers' compensation. Ask who actually runs the crew, whether subcontractors pour the concrete and set the steel, and who is on site daily. A fast salesperson and a good builder are not always the same person. Check any lien history through your county records.
Bids, plans and the contract
Compare bids on identical plans. Ask each bidder to list building dimensions, post or frame type, sidewall height, roof pitch, steel gauge and color, door sizes, concrete thickness, insulation and who handles site preparation. Look for allowances, which are placeholder amounts for things not yet priced, because those are where bids creep. Ask for engineered, stamped plans where snow, wind or soil conditions require them. The contract should state price, payment schedule, start and finish estimates, change-order procedure and warranty terms. Do not pay a large deposit before materials are ordered, and ask whether the deposit is protected if the builder fails.
Site, concrete and utilities
Good buildings sit on good ground. Ask about drainage, grade, compaction and the base under the slab. Concrete is priced by the cubic yard, so a simple check helps. A 40 by 60 foot floor at 6 inches thick is 40 times 60 times 0.5, or 1,200 cubic feet, and dividing by 27 gives about 44 cubic yards before waste. Ordering a few percent over is normal. Settle who pays for power, water, trenching and permits. Have the electrician coordinate with the builder before the slab is poured so conduit is in place.
Change orders and closeout
Changes will come up. Insist that every one is written, priced and signed before the work happens. Keep a folder with plans, contracts, permits, inspection records and photos taken during construction, because you cannot see inside walls and slabs later. At the end, walk the building with a punch list and hold back a final payment until it is done. Get warranty papers, manufacturer paperwork for doors and roofing, and lien waivers from the builder and major suppliers.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
