Farm service guides and a state-by-state directory for farmers and ranchersA farm.FM network site · Farm news →
AgServicesDirectoryWho to call, state by state
Home › Guides › Aerial, Drone & Precision Services › Remote Water Level Monitoring Services

Remote Water Level Monitoring Services

Remote sensors on tanks, ponds and wells can tell you a pump failed before the cattle do, provided the sensor suits the tank and the signal gets out.

Aerial, Drone & Precision Services3 min read686 words

In short

  • Match the sensor type to the tank, well or pond, and ask for readings in gallons.
  • Test the signal and battery on site before you pay for the full system.
  • Set low-level and rapid-drop alerts, and name a second person to receive them.

Why water is worth watching

Livestock can go a long time without feed and not nearly that long without water, especially in heat. A float stuck open, a cracked line or a dead solar pump can empty a tank overnight. Remote monitoring replaces some of the drive to check every tank with a message on your phone. It does not replace walking the line now and then, but it does tell you which tank to visit first. The same idea applies to irrigation sumps, cisterns, grain-bin condensate sumps and stock ponds.

Choosing the sensor

Ultrasonic sensors sit above the water and measure the distance down to the surface. They are simple to mount on a tank lid, but foam, steam, wind and cobwebs can confuse them. Pressure transducers sit on the bottom and read the weight of water above them, which suits wells, ponds and deep tanks, though they can foul with silt and need periodic cleaning. Float switches only say high or low. Ask the provider why they picked the sensor for your tank, how it handles freezing, and how often it needs cleaning or recalibrating. Follow the manufacturer manual for mounting height and dead zones.

Turning level into gallons

Ask the service to report gallons, not only inches, so a reading means something at a glance. For a round tank, volume in cubic feet is pi times the radius squared times the depth, and one cubic foot holds about 7.48 gallons. An 8 foot tank holding 2 feet of water is 3.14 times 16 times 2, or about 100 cubic feet, which is about 752 gallons. If 100 head drink 15 gallons each on a hot day, which varies with temperature and animal type, that is 1,500 gallons, so that tank holds roughly half a day. Knowing this shows how fast an alert needs a response.

Power and signal

Most remote tanks have no electric line, so the sensor runs on a battery or a small solar panel. Ask the battery life in cold weather, and what the unit does when the battery is low. Next ask how data leaves the site: cell, satellite or a local radio network. Test the signal at the tank itself before buying. Some services report every few hours to save power, which is fine for slow changes and too slow for a broken line. Ask the reporting interval, and whether it speeds up when something is wrong.

Alerts and who gets them

Set a low-level alert high enough to give you time to drive out. Add a rapid-drop alert, since a fast fall suggests a leak or a gate left open. Put a second person on the list. Ask whether alerts come by text or call, and what happens if no one acknowledges. Check your water rights, well permits and any reporting rules with your state water agency, since monitoring data may matter if you report use.

Installation and upkeep

Ask who installs the unit, who climbs the tower, and who fixes it when a bull rubs it off. Protect cables from livestock and rodents. Keep the lid sensor clean, and test the alert once a season by lowering the level on purpose.

Mistakes to avoid

Do not mount a sensor where the float valve splashes it or where animals can rub it. Do not rely on one tank as proof that the whole system works, since a fault upstream can leave a tank full for a while and empty later. Avoid setting the low alert so close to empty that the warning arrives after the damage. Do not forget freezing: ice can lock a float, crack a transducer cable or give false readings. Record the normal daily swing for each tank in the first month, so you know what an odd reading looks like. Keep a spare sensor on hand during summer.

Find providers near you

Pick your state to see vets, custom operators, dealers, elevators and other farm services.

Keep reading