In short
- Ask whether accuracy means pass-to-pass or year-to-year.
- Measure offsets by tape, write them down, and keep the sheet in the cab.
- Test overlap and wander before you accept the setup.
What a setup service does
A guidance setup service mounts the receiver, connects the steering controller, and then tunes the system to your tractor. That tuning matters. A properly set up unit follows a line smoothly, while a poor one snakes or overshoots on turns. The service should enter your vehicle dimensions, calibrate the steering sensors, tune the aggressiveness of the response, and teach you how to create and save lines. Ask which of those steps they perform and whether they leave you written settings you can restore if something resets.
Understand accuracy claims
Providers quote accuracy in inches, and the number only means something with context. Pass-to-pass accuracy describes how well one pass matches the next one run a few minutes later. Year-to-year or repeatable accuracy describes returning to the same line months later, and that takes a higher grade of correction signal. Ask which type the quote refers to, and what correction source delivers it. If you plan to strip-till, plant on the same rows, or run controlled traffic, you need repeatable accuracy. For tillage and spraying, a lower grade may be enough. Do not pay for more than the job needs.
Measurements the technician should take
The system needs accurate geometry. That includes the antenna height and its position left or right of the tractor centerline, and the implement offset. As a worked example, say your planter is 40 feet wide and the hitch pulls it centered. Then the offset is zero. If the planter sits 2 feet to the right of center, the offset is 2 feet right, and every pass will be 2 feet off until it is entered. Ask the technician to measure, not estimate, and to record each number on a sheet kept in the cab.
Setting up lines and headlands
Ask the service to show you how to set an AB line, a curved line, and a pivot line, and how to name and save fields. Practice creating a headland boundary and setting turn behavior. Many growers get frustrated because lines are saved in the wrong place or overwritten. Ask for a short written routine for starting each field. Check that the same line works across tractors and implements if you move the display between machines. Follow the manufacturer's manual for any steps specific to your steering system.
Testing the result
A simple test tells you a lot. On a flat, open field, run a pass, turn around, and run the next pass at implement width. Then look at the overlap or gap from end to end. Drive a pass at slow, normal, and fast speeds and watch for wandering. Check for drift by returning at the end of the day and testing again. If you see gaps, ask the installer to recheck the offset and tuning before you accept the job. Write down the date and settings so you can compare later.
Questions about service and cost
Ask what the service call costs, whether the first tuning visit is included, and how fast they respond during planting. Ask about annual signal fees and software updates. If a steering system is mounted to older tractors, ask how the shop handles hydraulic differences, which can affect performance. Check the equipment manual for steering wheel and operator safety instructions, since the system is not a driver. Look up your state in the directory for guidance service listings.
Habits that keep it accurate
Recheck the setup whenever you change tires, hitch position, or implement. A new tire size changes the wheel angle calibration, and a different drawbar position changes the offset. Keep the antenna clean, mounted tight, and clear of anything that blocks the sky. Before each season, drive a test pass and compare it to last year's saved line. If the display shows warnings, read the manual instead of clearing them. Small checks in the shop take ten minutes and save a ruined row of seedlings.
Find providers near you
Pick your state to see vets, custom operators, dealers, elevators and other farm services.
